ClearOne AP10 Especificaciones descargar pdf (Pagina 16)

Configuration ~ DIP Switch Settings

Technical Services Group ~ 1-800-283-5936 (USA) ~ 1-801-974-3760

Receive AGC

DIP switch 3 enables/disables the automatic gain control (AGC) function in the

firmware. The AGC feature is designed to keep soft and loud telephone participants

at a consistent level.

DIP Switch Position Description

3* On (up) Receive AGC enabled

3 Off (down) Receive AGC disabled

Auto-answer

DIP switch 4 enables/disables auto-answer. When enabled, the AP10 will

automatically answer incoming calls after one complete valid ring has been detected.

DIP Switch Position Description

4 On (up) Auto-answer enabled

4* Off (down) Auto-answer disabled (follows

the serial command)

Auto-disconnect

DIP switch 5 enables/disables auto-disconnect.

DIP Switch Position Description

5* On (up) Auto-disconnect enabled

5 Off (down) Auto-disconnect disabled

Call progression/loop

DIP switch 6 selects either loop drop or call-progress mode. Call-progress mode will

disconnect the line upon detection of a valid call-progress signal. Call progress will

detect the reorder tone and busy signal for the U.S., Canada, United Kingdom,

France, and Germany.

DIP Switch Position Description

6 On (up) Call progression enabled

6* Off (down) Loop drop enabled

To issue the AA (auto-

answer) serial command to

toggle auto-answer, DIP

switch 4 must be off (down).

In order for the settings on

DIP Switch 6 to function,

DIP Switch 5 must be on

(up). Auto-disconnect must be

enabled before either Call

Progression or Loop Drop are

applicable.

✍

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Sin comentarios

ClearOne AP10 Especificaciones Pagina 16